PC preform softening lamp factory price list

Sun, 19 Jul 2026 19:49:12 +0800

Sidel Softening Lamps: No Hacks, Just a Direct Swap

If you’re running Sidel blowing machines—whether you’ve got the old-school SBOs or the newer Matrix series—you know the headache of replacing lamps. You don’t want a “project.” You just want the machine to run. That’s why we make our infrared softening lamps as a true drop-in replacement. No messing with the oven frames. No rewiring the controllers. You just swap them out and get your preforms up to temp. The fit is everything. Here’s the thing: if the footprint is off by even a fraction, you’re asking for trouble. We match the OEM length and electrical specs exactly. They slide right into the sockets without you having to force the glass. Whether you’re on standard or high voltage, we dial in the wattage to hit that specific heat density you need. Why? Because loose contacts lead to arcing. It’s that simple. We keep the tolerances tight so the lamps sit firmly in the reflectors where they belong. Getting the heat where it actually matters We use high-purity quartz glass because these things take a beating from rapid thermal cycling. But the real secret is in the coatings. We’ve shifted the infrared spectrum so the heat actually penetrates the PC or PET wall. It doesn’t just bake the surface. This stops those annoying “cold spots” that leave you with uneven wall thickness in your finished bottles. One heads-up, though. High-wattage lamps are powerful, but they put more pressure on your cooling fans. If you decide to push the wattage past factory specs to speed up your cycles, just double-check your airflow. You don’t want to warp your lamp holders because the heat has nowhere to go. Less downtime, less stress Installation is a non-event. You pull the burnt-out tube, plug in ours, and you’re done. No adapters. No custom brackets. Nothing to fiddle with during a tight maintenance window. Since these match the Sidel requirements perfectly, your heat profile stays consistent across the whole oven. Your blow-up process stays stable, and you can actually get back to work.

PETC preform softening emitter spare bulb

Sat, 06 Jun 2026 06:28:37 +0800

On a blow molding line, the heating tunnel keeps moving—downtime doesn’t. When a PETC preform softening emitter takes a dive, the molds sit idle, preforms cool off, and the schedule slips. You need a replacement bulb that drops in and performs, without forcing you to retune the entire heating profile.

What matters under the hood

We build PETC preform softening emitter spare bulbs as direct-fit units for blow molders, engineered to match OEM heating requirements. They’re short-wave infrared (IR) emitters—halogen filament inside a quartz tube—so response is fast and temperature control stays tight in the preform heating tunnel. Typical ratings cover 1200–1500 W, 230 V, with standard R7s connectors and OD/length dimensions that align with common recessed sockets. The spectral output is tuned for PET, so the energy goes into heating the preform wall instead of overheating the neck finish. Every bulb is tested for consistent resistance and output tolerance, so you can swap one in and keep the same heating curve.

Softening on Smart IR Heating Solutions

PC preform softening lamp factory price list

Sidel Softening Lamps: No Hacks, Just a Direct Swap

PETC preform softening emitter spare bulb

What matters under the hood